BikeCAD Pro How To Forum

Hello, I'm confused what measurement to use for the bottom center head tube measurement for my Anvil Journeyman in the Jig setup tab.

There are two (X) and (Y).

Thanks!

Hi Brent.

Long time user, first time poster. . . does that make sense?

Anywho, the subject line poses my question nicely. I understand that it is in the .CSV output, but is there a way to display it onto the working screen? i have searched the forum and the internet and have not been able to figure out how to do it, or if it is even possible.

Thanks for your help and for putting out a great product.

-Mo

With 9.16 I am unable to adjust the top tube extension above or below head tube and seat tube extension above top tube. It only has from center of intersection. Please advise.

thanks,

rich

Hello!
I noticed the newest version has several crankset specs under the 'Standard' dropbox. I have a couple of questions I hope someone can help me answer...

Hi!

I have a small issue with the 9.15 version: the seatstays/seat-tube mitering templates are not the same for both sides (my design is symmetric). The drive side seems OK, but the non-drive side looks as is the seatstays was placed much more outside. On the seatstay view of the design everything looks ok, it's only on the mitering pdf.

It's not a big issue as I usually use one template and then copy the 1st cut on the other one, but it's the first time I see this....

Any idea ?

Thanks !

Francois

Is it possible to make a through hole miter with miter templates from BikeCAD? I mean I want to make a cargo and need a hole for the middle column. Can I make it?

Is there any way to put the bottom bracket on the downtube. I'm building a low chopper and need to move the pedal up on the bottom bracket approx 6 inches so they clear the ground.

I only started working with BikeCAD Pro recently. So maybe I have not yet found the functionality I'm looking for albeit I have extensively searched the Forum and FAQs.

We are specialized in offering titanium frames from different manufacturers to customers with special requirements in terms of geometry or functionality. So far I have created these drawings with AutoCAD.

Don't know why, it has run great up until now. Java is current and I've restarted the program and PC with no change. Probably something simple that I am over looking. Thanks

I can't seem to be able to edit the fork length and offset in the dialog box.

Anyone know what I'm doing wrong?

I can enter a different value for a custom fork but the drawing doesn't update and doesn't save the dimensions.